egyptdanax.blogg.se - Phoenix suite usb driver

#Phoenix suite usb driver how to#
#Phoenix suite usb driver install#
#Phoenix suite usb driver drivers#
#Phoenix suite usb driver driver#

If you install the system on a USB drive, we recommend you use a USB drive with high performance and capacity of more than 6G.

We recommend that you use the system on devices with Intel Atom series CPUs, which will have the best compatibility.

You should make a backup even though the original data won't be affected as the system is installed on the hard disk.

Select the installation method via setup from the USB drive or install to hard disk on the operation interface. Double click the setup program on Windows.

#Phoenix suite usb driver how to#

How to install the systemĭownload the setup program of Phoenix OS (x86). Recommended computer settingsĬomputers with Intel x86 processor and internal storage of more than 2G from the past five years. It can be installed on hard disk for operation, without affecting the original document system. you can follow this instructions.The Phoenix OS(x86) can run on devices with Intel x86 series CPUs. Using Phoenixcard SDcard Production funtion. When you first download fails in 88%, you download again, But remember click normal mode. There have two Method to solve this problem. If your nand is not MT29F64G08CBA, forget it. Unfortunately, marsboard A20 use 8G nand (MT29F64G08CBA), it is bad support in PhoenixSuit, when you download large firmware ( android is small ), it will Failed in 88%. This happens at process occurs 88%, when you download large firmware like ubuntu or debian, those fileware are almost 2G.Īllwinner A20 support many nand, But for some NAND is bad support in PhoenixSuit. If the flashing has aborted ,it could possibly be an error with the update.img, you can either try to redo the operations above or make the update.img again! Recommendation: Back up all data, select "Yes" to upgrade via formatting to avoid error in some program or data after upgrading.Īfter the programming is completed, press "OK" to complete the upgrade. If you select "No" to upgrade in common mode, it will retain user data. If you select "Yes" to upgrade via formatting, it will clear all user data. Select the upgrade mode in the dialog box, as shown below "Īfter selecting the firmware package, Power down the MarsBoard and connect the MarsBoard to the computer then let the board go to FEL mode after the program should detect the device. Click button, select the firmware package, and click " Open. PhoenixSuit has been successfully installed as shown below, click "Close".Ĭlick PhoenixSuit.exe, Tool page is shown as belowĬlick the button to enter upgrade mode.

#Phoenix suite usb driver drivers#

The drivers were successfully installed on this computer as shown below.

#Phoenix suite usb driver driver#

Then unzip it and double click PhoenixSuitV1.07_EN.msi, you will see the following interface.ĭuring the installation process, it may require to install the driver as shown in the following picture, just select "下一步"(means Next) to install the driver as shown below.

a micro USB cable with one side plugged in to the OTG port of MarsBoard and the other side plugged into the USB port on PC.ĭownload the file (PhoenixSuitV1.0.7) from here.

a PC running Windows (XP 32/64bit, Windows 7 32/64 bit).

What you will need to flash the board is: You can always flash the MarsBoard, it never bricks (as the name :)) unless some hardware damage occurs.

2.2 Failed in download process occurs 88%.

2.1 Using PhoenixSuit to flash Firmware.